宏旭定制 浇筑式防撞墙模具 中心防撞墙模具 宏旭定制 浇筑式防撞墙模具 中心防撞墙模具 he introduction of the use steps of the central anti-collision wall mold is mainly based on the size of the prefabricated block of the anti-collision wall and the construction conditions. Because the length of the anti-collision wall mold is not fixed, most of the molds are 1 meter long. It is very convenient to carry, dismantle and assemble, According to the pouring type anti-collision wall mold, the length of the central anti-collision wall mold and the production period determine the customized quantity of the template, which can effectively save the proleyu����.txtduction cost. Pouring method of central anti-collision wall mold In order to ensure the accuracy of the mold in the production of the components of the anti-collision wall, the drawings of the steel mold of the anti-collision wall are often needed, which can not only ensure the smooth production, but also ensure the timeliness of the processing, and kill two birds with one stone. The central anti-collision wall mold uses the place to divide into the city anti-collision wall component and the highway anti-collision wall component, the city anti-collision wall component general height is relatively small, the length is more than 2 meters, above places the steel bar railing, can display the citys beauty, also can play the protective role very well. However, the height of the anti-collision wall used in the expressway is mostly between 80-120cm, and there is no need to place steel bars on it, so the anti-collision effect of pure concrete anti-collision wall components is better.